Benachrichtigungen
Alles löschen
Barry Jindra
Gruppe: Registriert
Beigetreten: 2022/05/28
Active Member
1
| Mini corners. | Vor 3 months | |
| I went from 3.5 to 3.9s. All parts and assembly went good. D... | Vor 3 months | |
| I went from 3.5 to 3.9s. All parts and assembly went good. D... | Vor 3 months | |
|
I knew it was in there somewhere, I have seen it before but ... Im Forum Hardware, firmware and software help |
Vor 1 year | |
|
Loading too much filament to hot end Im Forum Hardware, firmware and software help |
Vor 1 year | |
|
I updated to 3.13.2 and now my sd card is not reading either... Im Forum Hardware, firmware and software help |
Vor 2 years | |
| downloaded and flashed printer fine. did the calibration and... | Vor 2 years | |
| Where did you find the HEX files for 3.13.2? I am at 3.13.0 ... | Vor 2 years | |
|
Will not load filament into extruder Im Forum Hardware, firmware and software help |
Vor 4 years |