Activité
 
Notifications
Clear all
Balazs
Balazs
Groupe: Enregistré
A(ont) rejoint: 2022/02/07
Active Member
1
I've printed and added a C ring to the X axis rod to the rig...

Dans le forum Input Shaper (MINI)

il y a 1 year
How much Hz is the frequency of that dead center?

Dans le forum Input Shaper (MINI)

il y a 1 year
Great, we have new profiles in PS, thank you Prusa. Unfortun...

Dans le forum Input Shaper (MINI)

il y a 1 year
Same issue here. +I have a PLA which is a bit weaker and bri...

Dans le forum Input Shaper (MINI)

il y a 1 year
I'm using mine on 6 squash ball feet, no issue. However I tr...

Dans le forum Input Shaper (MINI)

il y a 1 year
You have to re-slice everything if you want to use it with t...

Dans le forum Input Shaper (MINI)

il y a 1 year
Filament unload also has some issues. It cannot unload the f...

Dans le forum Input Shaper (MINI)

il y a 1 year
The only issue I have - and it's repeating - the X homing er...

Dans le forum Input Shaper (MINI)

il y a 1 year
I'm using Bondtech extruder and this firmware - no issue so ...

Dans le forum Input Shaper (MINI)

il y a 1 year
I was just about to sell my Mini, having an MK4 and a fresh ...

Dans le forum Input Shaper (MINI)

il y a 1 year
Just for the record - this modification works fine.

Dans le forum Hardware, firmware and software help

il y a 3 years
Silk contains a bit of elastic component which causes this f...

Dans le forum Hardware, firmware and software help

il y a 3 years
Or maybe not... I've tested the X axis offline moving back a...

Dans le forum Hardware, firmware and software help

il y a 3 years
I have the same sound mostly during solid infill layers. I t...

Dans le forum Hardware, firmware and software help

il y a 3 years
I think that small part is printed with a lower speed - and ...

Dans le forum How do I print this? (Printing help)

il y a 3 years
Same topic, some explanation:

Dans le forum How do I print this? (Printing help)

il y a 3 years
Check the Volumetric Flow rate after slicing in your slicer....

Dans le forum How do I print this? (Printing help)

il y a 3 years
Partager :