Prusa3D Forum

Notifications

Clear all

Backfisch_in_3D

Grupa: Zarejestrowany

Dołączył: 2025/08/15

Active Member

	Also my printer now sometimes bluescreens on startup. It bee... In forum General discussion, announcements and releases	1 month temu
	This has also been the case even before installing 6.4.0-alp... In forum General discussion, announcements and releases	1 month temu
	If you have enabled the Expert mode in PrusaSlicer you can e... In forum Hardware, firmware and software help	2 months temu
	Both belts influence each other, there is no way around this... In forum Assembly and first prints troubleshooting	2 months temu
	My tape-measure measurements are roughly the same, but the g... In forum Hardware, firmware and software help	2 months temu
	I just tried re-tensioning to 98/92, and the gap this causes... In forum Hardware, firmware and software help	2 months temu
	Aha! That makes more sense! Didnt think that the belt length... In forum Hardware, firmware and software help	2 months temu
	New belt tuning frequencies (98 / 92 Hz) - Discussion (is it... In forum Hardware, firmware and software help	2 months temu

Statystyki Forum

585 Fora

68.6 K Tematy

480.2 K Posty

11 Online

76.9 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte