Azonic3D – Activité – Prusa3D Forum

Notifications

Clear all

Azonic3D

Groupe: Enregistré

A(ont) rejoint: 2025/07/23

Eminent Member

	Glitch in the Matrix? (How did this happen?) Dans le forum How do I print this? (Printing help)	il y a 6 months
	Thank you for the insightful reply. These are all great tips... Dans le forum How do I print this? (Printing help)	il y a 7 months
	In this case, putting plain text is proving difficult due to... Dans le forum How do I print this? (Printing help)	il y a 7 months
	Tips for printing QR codes? Dans le forum How do I print this? (Printing help)	il y a 7 months
	PETG-CF "stringing"? Humidity levels or CF strands? Dans le forum How do I print this? (Printing help)	il y a 7 months
	Got it. Thank you for the feedback! I guess since I'd seen o... Dans le forum How do I print this? (Printing help)	il y a 7 months
	Chamber Temps for Prusament PETG-CF? Dans le forum How do I print this? (Printing help)	il y a 7 months
	As a follow-up, I went into the Filament settings in PrusaSl... Dans le forum Hardware, firmware and software help	il y a 7 months
	I'm having this same issue. I'm trying to print Prusament PE... Dans le forum Hardware, firmware and software help	il y a 7 months
	Switch from stock nozzle to Obxidian 0.6 - Recalibrate? Dans le forum Hardware, firmware and software help	il y a 7 months
	Recommended nozzle for PETG-CF on the Core One? Dans le forum How do I print this? (Printing help)	il y a 7 months
	Thanks for these insights! Any advice on the level of humidi... Dans le forum How do I print this? (Printing help)	il y a 7 months
	Thanks for that insight. I do have a roll of PETG Carbon Fib... Dans le forum How do I print this? (Printing help)	il y a 8 months
	Print PETG and PLA in the same build/print? Dans le forum How do I print this? (Printing help)	il y a 8 months

Page 3 / 3 Précédent

Statistiques du forum

595 Forums

69.7 K Sujets

487.6 K Messages

15 En-ligne

79.8 K Membres

Le dernier des messages: Core One kalibriert y Achse nicht Notre nouveau membre: Marcel Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé