Notifications
Clear all
Asus1357
Asus1357
Skupina: Registrovaný
Přidal se: 2018/12/26
Trusted Member
3
I have not received my 5 head as of yet (but soon :)) Though...

In forum General discussion, announcements and releases

před 1 year
Thank you for that bit of good info. I will pay great heed t...

In forum Assembly and first prints troubleshooting

před 1 year
Fingers crossed!!!!!

In forum Assembly and first prints troubleshooting

před 1 year
I have not heard anything yet as well. I wonder if anyone ha...

In forum General discussion, announcements and releases

před 1 year
ok that is great, thanks for the info!

In forum Assembly and first prints troubleshooting

před 1 year
Can't wait to try that. One issue.. Still waiting for my ema...

In forum Assembly and first prints troubleshooting

před 1 year
That would be interesting to know what you get for a reading...

In forum Assembly and first prints troubleshooting

před 1 year
Assemble torque specs

In forum Assembly and first prints troubleshooting

před 1 year
Though that is just the last wait (most are waiting to get a...

In forum General discussion, announcements and releases

před 1 year
EEK!I can only hope this result was due to a overlooked / in...

In forum General discussion, announcements and releases

před 1 year
Printer Settings-General-Firmware-G-code flavor:

In forum Hardware, firmware and software help

před 1 year
What is this email you all speak about?? The one one that st...

In forum General discussion, announcements and releases

před 1 year
I hope that although you said it was a temp/perm fix you do ...

In forum Hardware, firmware and software help

před 1 year
Ok, so I do not know how these are boxed up. Are the large t...

In forum Hardware, firmware and software help

před 1 year
Looks good! Worthwhile to make for sure.

In forum User mods - OctoPrint, enclosures, nozzles, ...

před 1 year
Yes that is my issue though I do note that there are small a...

In forum User mods - OctoPrint, enclosures, nozzles, ...

před 1 year
I will give that a try as well. While I had no issues with t...

In forum User mods - OctoPrint, enclosures, nozzles, ...

před 1 year
Thanks I will give it a go today

In forum Hardware, firmware and software help

před 1 year
REV) and firmware 3.13.0 Thermal anomalies

In forum Hardware, firmware and software help

před 1 year
Not to detract from your issue (very unfortunate) but is thi...

In forum Hardware, firmware and software help

před 1 year
Stránka 3 / 5
Share: