Notifications
Clear all
Asus1357
Asus1357
Skupina: Registrovaný
Přidal se: 2018/12/26
Trusted Member
3
No I did not. I just squeezed them in the best I could. I o...

In forum General discussion, announcements and releases

před 2 days
Love to try to print this model. I did not have back surgery...

In forum Awesome prints (Hall Of Fame)

před 1 month
That is my problem. Yes it look like that but it is not for ...

In forum General discussion, announcements and releases

před 1 month
Side sensor collets

In forum General discussion, announcements and releases

před 1 month
I wound up going to version 3.11 and re calibrate then upgra...

In forum Hardware, firmware and software help

před 1 month
By any chance did you try installing the latest firmware. If...

In forum Hardware, firmware and software help

před 3 months
Yes I know you can turn it off but it only stays off if you ...

In forum General discussion, announcements and releases

před 3 months
The cable at the IR sensor board and the einsy board are cor...

In forum General discussion, announcements and releases

před 3 months
Looking a bit deeper I can see the voltage change at the ir ...

In forum General discussion, announcements and releases

před 3 months
filament sensor issue

In forum General discussion, announcements and releases

před 3 months
Filament sensor always reads 0

In forum Hardware, firmware and software help

před 3 months
Over 1000 hours and not a single issue related to the actual...

In forum General discussion, announcements and releases

před 8 months
The issue people mentioned with plastic parts was never wher...

In forum General discussion, announcements and releases

před 8 months
Rather than just say Loctite 243 (red or even blue) will dam...

In forum General discussion, announcements and releases

před 8 months
I will take some pictures on the next print. Oddly enough I ...

In forum How do I print this? (Printing help)

před 9 months
petg only sticks to 2 of 5 nozzles

In forum How do I print this? (Printing help)

před 9 months
Thanks for the comment

In forum Hardware, firmware and software help

před 10 months
Thank you for that video. I always like having detailed repa...

In forum Hardware, firmware and software help

před 10 months
i went in for a long head bicep tendon repair(cut the tendon...

In forum User mods - OctoPrint, enclosures, nozzles, ...

před 10 months
Thanks for the reply. i am @ 12704-158 Ave Edmonton, Alberta...

In forum User mods - OctoPrint, enclosures, nozzles, ...

před 10 months
Stránka 1 / 5
Share: