Notifiche
Cancella tutti
Astrobirder
Gruppo: Registrato
Registrato: 2017/05/15
Active Member
1
|
Thank! I’ll give it a go when 2.4 hits release! Nel forum PrusaSlicer |
3 years fa | |
|
Prusaslicer 2.3.3 not resolving mDNS name when underlying Wi... Nel forum PrusaSlicer |
3 years fa | |
|
Here you can see that the filament under the lettering will ... Nel forum PrusaSlicer |
3 years fa | |
|
Force full layer ironing in mid-print Nel forum PrusaSlicer |
3 years fa | |
|
Prusaslicer 2.3.0 - Auto-update Nel forum PrusaSlicer |
4 years fa | |
|
I too just had this issue on a longer print. MK2.5, F/W 3.8... Nel forum Hardware, firmware and software help |
5 years fa | |
|
I'm not sure if this is the place to ask/discuss this, but i... Nel forum PrusaSlicer |
5 years fa | |
|
Here's the Larger image of PrusaSlicer as requested, and a p... Nel forum PrusaSlicer |
6 years fa | |
|
Extrusion Interruptions in "perfect" cylinder Nel forum PrusaSlicer |
6 years fa |