Notifications
Clear all
Astrobirder
Groupe: Enregistré
A(ont) rejoint: 2017/05/15
Active Member
1
|
Thank! I’ll give it a go when 2.4 hits release! Dans le forum PrusaSlicer |
il y a 3 years | |
|
Prusaslicer 2.3.3 not resolving mDNS name when underlying Wi... Dans le forum PrusaSlicer |
il y a 3 years | |
|
Here you can see that the filament under the lettering will ... Dans le forum PrusaSlicer |
il y a 3 years | |
|
Force full layer ironing in mid-print Dans le forum PrusaSlicer |
il y a 3 years | |
|
Prusaslicer 2.3.0 - Auto-update Dans le forum PrusaSlicer |
il y a 4 years | |
|
I too just had this issue on a longer print. MK2.5, F/W 3.8... Dans le forum Hardware, firmware and software help |
il y a 5 years | |
|
I'm not sure if this is the place to ask/discuss this, but i... Dans le forum PrusaSlicer |
il y a 5 years | |
|
Here's the Larger image of PrusaSlicer as requested, and a p... Dans le forum PrusaSlicer |
il y a 6 years | |
|
Extrusion Interruptions in "perfect" cylinder Dans le forum PrusaSlicer |
il y a 6 years |