Avisos
Vaciar todo
Arrakis90
Grupo: Registrado
Registrado: 2021/10/19
Active Member
1
|
Thanks, Mike. I checked the bed screws just now and didn't f... En el foro Hardware, firmware and software help |
hace 4 months | |
|
Bump. Just another point, this shift is always in the Y dire... En el foro Hardware, firmware and software help |
hace 4 months | |
|
Shift occurs at same Z height on most prints En el foro Hardware, firmware and software help |
hace 4 months | |
|
Thanks for the help @BogdanH, I was able to get my printer w... En el foro Hardware, firmware and software help |
hace 3 years | |
|
Hey Bogdan, thanks for the clarification. I just spent about... En el foro Hardware, firmware and software help |
hace 3 years | |
|
Does that involve performing every step here: En el foro Hardware, firmware and software help |
hace 3 years | |
|
Clicking and filament grinding out of nowhere En el foro Hardware, firmware and software help |
hace 3 years |