Deutsch
Foren
Mitglieder
arnaud.d
Aktivität
 
Benachrichtigungen
Alles löschen
arnaud.d
arnaud.d
Gruppe: Registriert
Beigetreten: 2016/01/07
Eminent Member
2
Profil Aktivität
If it helps, I can get some sent to me with my next order an...

Im Forum Assembly and first prints troubleshooting

 Vor 7 years
Great prints. Where did you get the globe?

Im Forum Others (Archive)

 Vor 7 years
The problem is that it is high-precision 1.9mm ID and not re...

Im Forum Assembly and first prints troubleshooting

 Vor 7 years
I have issue with some horizontal lines to solve but I reall...

Im Forum Others (Archive)

 Vor 7 years
NYC Taurus with MMU

Im Forum Awesome prints (Hall Of Fame)

 Vor 7 years
If you unmount the multiplexer and push some filament throug...

Im Forum Others (Archive)

 Vor 7 years
I use filament from amazon ou filament.ca ... and i have als...

Im Forum Others (Archive)

 Vor 7 years
I post a lot but ...

Im Forum Others (Archive)

 Vor 7 years
I have some hard time printing ABS (without enclosure) My is...

Im Forum Others (Archive)

 Vor 7 years
😀

Im Forum Others (Archive)

 Vor 7 years
Thanks i will try this after work !

Im Forum Others (Archive)

 Vor 7 years
Yes I do the same but i use octoprint for remote surveillanc...

Im Forum Others (Archive)

 Vor 7 years
Octoprint and MMU

Im Forum Others (Archive)

 Vor 7 years
Print Quality

Im Forum Others (Archive)

 Vor 7 years
So it was jammed inside the ptfe, i put a new one and evert...

Im Forum Others (Archive)

 Vor 7 years
Have you tried any pre-sliced models? It was marvin from p...

Im Forum Others (Archive)

 Vor 7 years
Ok i will try this after work. Thanks It was the first prin...

Im Forum Others (Archive)

 Vor 7 years
Take out the PTFE tube; unscrew the heat break. Ok so i hol...

Im Forum Others (Archive)

 Vor 7 years
So i removed nozzle and heat sink ... the filament is jammed...

Im Forum Others (Archive)

 Vor 7 years
Filament jammed

Im Forum Others (Archive)

 Vor 7 years
Seite 1 / 2
Teilen: