Italiano
Forum
Utenti
arnaud.d
Attività
 
Notifiche
Cancella tutti
arnaud.d
arnaud.d
Gruppo: Registrato
Registrato: 2016/01/07
Eminent Member
2
Profilo Attività
If it helps, I can get some sent to me with my next order an...

Nel forum Assembly and first prints troubleshooting

 8 years fa
Great prints. Where did you get the globe?

Nel forum Others (Archive)

 8 years fa
The problem is that it is high-precision 1.9mm ID and not re...

Nel forum Assembly and first prints troubleshooting

 8 years fa
I have issue with some horizontal lines to solve but I reall...

Nel forum Others (Archive)

 8 years fa
NYC Taurus with MMU

Nel forum Awesome prints (Hall Of Fame)

 8 years fa
If you unmount the multiplexer and push some filament throug...

Nel forum Others (Archive)

 8 years fa
I use filament from amazon ou filament.ca ... and i have als...

Nel forum Others (Archive)

 8 years fa
I post a lot but ...

Nel forum Others (Archive)

 8 years fa
I have some hard time printing ABS (without enclosure) My is...

Nel forum Others (Archive)

 8 years fa
😀

Nel forum Others (Archive)

 8 years fa
Thanks i will try this after work !

Nel forum Others (Archive)

 8 years fa
Yes I do the same but i use octoprint for remote surveillanc...

Nel forum Others (Archive)

 8 years fa
Octoprint and MMU

Nel forum Others (Archive)

 8 years fa
Print Quality

Nel forum Others (Archive)

 8 years fa
So it was jammed inside the ptfe, i put a new one and evert...

Nel forum Others (Archive)

 8 years fa
Have you tried any pre-sliced models? It was marvin from p...

Nel forum Others (Archive)

 8 years fa
Ok i will try this after work. Thanks It was the first prin...

Nel forum Others (Archive)

 8 years fa
Take out the PTFE tube; unscrew the heat break. Ok so i hol...

Nel forum Others (Archive)

 8 years fa
So i removed nozzle and heat sink ... the filament is jammed...

Nel forum Others (Archive)

 8 years fa
Filament jammed

Nel forum Others (Archive)

 8 years fa
Pagina 1 / 2
Condividi: