Čeština
Fóra
Uživatelé
arnaud.d
Aktivita
 
Notifications
Clear all
arnaud.d
arnaud.d
Skupina: Registrovaný
Přidal se: 2016/01/07
Eminent Member
2
Profile Aktivita
If it helps, I can get some sent to me with my next order an...

In forum Assembly and first prints troubleshooting

 před 7 years
Great prints. Where did you get the globe?

In forum Others (Archive)

 před 7 years
The problem is that it is high-precision 1.9mm ID and not re...

In forum Assembly and first prints troubleshooting

 před 7 years
I have issue with some horizontal lines to solve but I reall...

In forum Others (Archive)

 před 7 years
NYC Taurus with MMU

In forum Awesome prints (Hall Of Fame)

 před 7 years
If you unmount the multiplexer and push some filament throug...

In forum Others (Archive)

 před 7 years
I use filament from amazon ou filament.ca ... and i have als...

In forum Others (Archive)

 před 7 years
I post a lot but ...

In forum Others (Archive)

 před 7 years
I have some hard time printing ABS (without enclosure) My is...

In forum Others (Archive)

 před 7 years
😀

In forum Others (Archive)

 před 7 years
Thanks i will try this after work !

In forum Others (Archive)

 před 7 years
Yes I do the same but i use octoprint for remote surveillanc...

In forum Others (Archive)

 před 7 years
Octoprint and MMU

In forum Others (Archive)

 před 7 years
Print Quality

In forum Others (Archive)

 před 7 years
So it was jammed inside the ptfe, i put a new one and evert...

In forum Others (Archive)

 před 7 years
Have you tried any pre-sliced models? It was marvin from p...

In forum Others (Archive)

 před 7 years
Ok i will try this after work. Thanks It was the first prin...

In forum Others (Archive)

 před 7 years
Take out the PTFE tube; unscrew the heat break. Ok so i hol...

In forum Others (Archive)

 před 7 years
So i removed nozzle and heat sink ... the filament is jammed...

In forum Others (Archive)

 před 7 years
Filament jammed

In forum Others (Archive)

 před 7 years
Stránka 1 / 2
Share: