English
Forums
Members
arnaud.d
Activity
 
Notifications
Clear all
arnaud.d
arnaud.d
Group: Registered
Joined: 2016/01/07
Eminent Member
2
Profile Activity
If it helps, I can get some sent to me with my next order an...

In forum Assembly and first prints troubleshooting

 7 years ago
Great prints. Where did you get the globe?

In forum Others (Archive)

 7 years ago
The problem is that it is high-precision 1.9mm ID and not re...

In forum Assembly and first prints troubleshooting

 7 years ago
I have issue with some horizontal lines to solve but I reall...

In forum Others (Archive)

 7 years ago
NYC Taurus with MMU

In forum Awesome prints (Hall Of Fame)

 7 years ago
If you unmount the multiplexer and push some filament throug...

In forum Others (Archive)

 7 years ago
I use filament from amazon ou filament.ca ... and i have als...

In forum Others (Archive)

 7 years ago
I post a lot but ...

In forum Others (Archive)

 7 years ago
I have some hard time printing ABS (without enclosure) My is...

In forum Others (Archive)

 7 years ago
😀

In forum Others (Archive)

 7 years ago
Thanks i will try this after work !

In forum Others (Archive)

 7 years ago
Yes I do the same but i use octoprint for remote surveillanc...

In forum Others (Archive)

 7 years ago
Octoprint and MMU

In forum Others (Archive)

 7 years ago
Print Quality

In forum Others (Archive)

 8 years ago
So it was jammed inside the ptfe, i put a new one and evert...

In forum Others (Archive)

 8 years ago
Have you tried any pre-sliced models? It was marvin from p...

In forum Others (Archive)

 8 years ago
Ok i will try this after work. Thanks It was the first prin...

In forum Others (Archive)

 8 years ago
Take out the PTFE tube; unscrew the heat break. Ok so i hol...

In forum Others (Archive)

 8 years ago
So i removed nozzle and heat sink ... the filament is jammed...

In forum Others (Archive)

 8 years ago
Filament jammed

In forum Others (Archive)

 8 years ago
Page 1 / 2
Share: