Notifications
Clear all
ArkoXS
Grupa: Zarejestrowany
Dołączył: 2021/05/01
Active Member
1
|
Z axis stepper stays active after printjob In forum Hardware, firmware and software help |
3 years temu | |
| Just did a selftest an although the y belt tension was repor... | 5 years temu | |
| @neophyl I've checked the grub screws and they seem to be se... | 5 years temu | |
| Thanks for the advice and the reference to the correct kb ar... | 5 years temu | |
| Strange offset in x and y during printing | 5 years temu |