Notifications
Clear all
ArkoXS
Skupina: Registrovaný
Přidal se: 2021/05/01
Active Member
1
|
Z axis stepper stays active after printjob In forum Hardware, firmware and software help |
před 2 years | |
| Just did a selftest an although the y belt tension was repor... | před 4 years | |
| @neophyl I've checked the grub screws and they seem to be se... | před 4 years | |
| Thanks for the advice and the reference to the correct kb ar... | před 4 years | |
| Strange offset in x and y during printing | před 4 years |