|
Okay,
I have checked the distance and it is 18,45 on both s... In forum Prusa i3 kit (Archive) |
před 7 years |
|
Jeff,
The distance from the print bed to the middle of the ... In forum Prusa i3 kit (Archive) |
před 7 years |
|
Jeff,
I have managed to take this video:
if you can pick ... In forum Prusa i3 kit (Archive) |
před 7 years |
|
Hi,
I am convinced that the problem is not due to misalignm... In forum Prusa i3 kit (Archive) |
před 7 years |
|
Hi,
On checking the live adjust Z level it was already at 0... In forum Prusa i3 kit (Archive) |
před 7 years |
|
Thanks very much - I was beginning to think that no-one had ... In forum Prusa i3 kit (Archive) |
před 7 years |
|
X-Axis problem In forum Prusa i3 kit (Archive) |
před 7 years |
|
Great, in that case, see my next question titled "X-Axis pro... In forum Prusa i3 kit (Archive) |
před 7 years |
|
Firmware In forum Prusa i3 kit (Archive) |
před 7 years |
|
Okay, finally moving forward with this I think.
I won't bor... In forum Prusa i3 kit (Archive) |
před 7 years |
|
Filip,
Okay, will try that.
Thanks, In forum Prusa i3 kit (Archive) |
před 7 years |
|
Thanks for the probe height advice.
The general area of sme... In forum Prusa i3 kit (Archive) |
před 7 years |
|
Filip,
Okay, I will do that.
I seem to be having conflicti... In forum Prusa i3 kit (Archive) |
před 7 years |
|
First Print Problems In forum Prusa i3 kit (Archive) |
před 7 years |
|
Kevin,
I will thanks, tomorrow. I need to sleep after that ... In forum Prusa i3 kit (Archive) |
před 8 years |
|
Filip,
Okay, thanks anyway. In forum Prusa i3 kit (Archive) |
před 8 years |
|
Filip,
How about a video:
Thanks, In forum Prusa i3 kit (Archive) |
před 8 years |
|
Thanks but that is the problem - I cannot go into any sub-me... In forum Prusa i3 kit (Archive) |
před 8 years |
|
Unable to calibrate In forum Prusa i3 kit (Archive) |
před 8 years |
|
I got an email 24 hours ago to say my printer was in transit... In forum General discussion, announcements and releases |
před 8 years |
