Andrew – Aktivita – Prusa3D Forum

Notifications

Clear all

Andrew

Skupina: Registrovaný

Přidal se: 2020/04/08

Estimable Member

	@neophyl Thanks I will look into that. Currently printing a ... In forum How do I print this? (Printing help)	před 5 years
	Trying that right now. I was following the instructions from... In forum How do I print this? (Printing help)	před 5 years
	Better picture of Jaggy Fuzz. Andrew better-shot.j... In forum How do I print this? (Printing help)	před 5 years
	Retraction or cooling issue on Lithophane In forum How do I print this? (Printing help)	před 5 years
	I will watch this one with interest too. Mine was gritty bea... In forum Assembly and first prints troubleshooting	před 5 years
	Thanks Joan I thought that might be the case but thought it ... In forum Assembly and first prints troubleshooting	před 5 years
	Is first layer calibration stored per material or not? In forum Assembly and first prints troubleshooting	před 5 years
	I will listen in on this one with interest. Mine is loud but... In forum Hardware, firmware and software help	před 5 years
	Thank you 👍 . Can't believe I missed that. Will sort it when... In forum Hardware, firmware and software help	před 5 years
	X Axis motor and belt adjustment query In forum Hardware, firmware and software help	před 5 years

Stránka 6 / 6 Předchozí

Fórum Statistiky

565 Fóra

63.6 K Témata

446.2 K Příspěvky

21 Online

68.9 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed