Prusa3D Forum

Notifications

Clear all

Andin

Groupe: Enregistré

A(ont) rejoint: 2021/03/16

Active Member

	My only question is, why have an ethernet port on the prusa ... Dans le forum User mods - OctoPrint, enclosures, nozzles, ...	il y a 3 years
	Should first layer PETG be squished with no visible lines in... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	Running the first layer calibration with PETG, is there an e... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	I had a thought, is there an expected thickness when running... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	Thanks, ill try that out later. I think I am at -1.658 on my... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	I also noticed that the side seem to pull up as the first la... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	I just tried to print the whistle again and it failed during... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	Here's a couple of pics, one is the nozzle covered in PETG a... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	@zoltan Just the Nozzle where the PETG is dispensed, thanks ... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	I'll take a picture or video of the issue and post it tonigh... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	NEWBIE - PETG First layer Calibration Questions Dans le forum Assembly and first prints troubleshooting	il y a 3 years

Statistiques du forum

535 Forums

59.7 K Sujets

427.8 K Messages

13 En-ligne

64.1 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé