|
ok it worked finally, OG setttings and no skipping, Thank yo... In forum Hardware, firmware and software help |
4 years ago |
|
@cwbullet thanks, ill reassemble the head and try again this... In forum Hardware, firmware and software help |
4 years ago |
|
it seems to be 2.5mm right now after i tightened it a bit In forum Hardware, firmware and software help |
4 years ago |
|
@tim-2 i just opened my printhead and it does look like the ... In forum Hardware, firmware and software help |
4 years ago |
|
Update: THe print finished and it clicked the entire time, t... In forum Hardware, firmware and software help |
4 years ago |
|
@tim-2 I just red through the article again, just to double ... In forum Hardware, firmware and software help |
4 years ago |
|
@swiss_cheese i am aware of this issue it happend during des... In forum Hardware, firmware and software help |
4 years ago |
|
@tim-2 The speed settings i changed in my first attempts to ... In forum Hardware, firmware and software help |
4 years ago |
|
@tim-2 i followed the guidlines from the prusa knowledge bas... In forum Hardware, firmware and software help |
4 years ago |
|
print Here it is In forum Hardware, firmware and software help |
4 years ago |
|
Fillament skipping on Parts of the print with close perimete... In forum Hardware, firmware and software help |
4 years ago |
