|
ok it worked finally, OG setttings and no skipping, Thank yo... Im Forum Hardware, firmware and software help |
Vor 4 years |
|
@cwbullet thanks, ill reassemble the head and try again this... Im Forum Hardware, firmware and software help |
Vor 4 years |
|
it seems to be 2.5mm right now after i tightened it a bit Im Forum Hardware, firmware and software help |
Vor 4 years |
|
@tim-2 i just opened my printhead and it does look like the ... Im Forum Hardware, firmware and software help |
Vor 4 years |
|
Update: THe print finished and it clicked the entire time, t... Im Forum Hardware, firmware and software help |
Vor 4 years |
|
@tim-2 I just red through the article again, just to double ... Im Forum Hardware, firmware and software help |
Vor 4 years |
|
@swiss_cheese i am aware of this issue it happend during des... Im Forum Hardware, firmware and software help |
Vor 4 years |
|
@tim-2 The speed settings i changed in my first attempts to ... Im Forum Hardware, firmware and software help |
Vor 4 years |
|
@tim-2 i followed the guidlines from the prusa knowledge bas... Im Forum Hardware, firmware and software help |
Vor 4 years |
|
print Here it is Im Forum Hardware, firmware and software help |
Vor 4 years |
|
Fillament skipping on Parts of the print with close perimete... Im Forum Hardware, firmware and software help |
Vor 4 years |
