alexw – Aktivita – Prusa3D Forum

Notifications

Clear all

alexw

Skupina: Registrovaný

Přidal se: 2017/09/07

Trusted Member

	Okay some more fiddling: I just noticed the following: s/mm=... In forum Others (Archive)	před 7 years
	Also, starting from a reset: the first time I run G1 E100 F1... In forum Others (Archive)	před 7 years
	Setting extruder steps per mm fails weirdly In forum Others (Archive)	před 7 years
	So I think that code must be for Slic3r, and the cura syntax... In forum Others (Archive)	před 7 years
	3. Change start g-code to raise head above bed to prevent PI... In forum Prusa i3 kit (Archive)	před 7 years
	Okay - comparing to my current code in Cura: G21 ; set unit... In forum Others (Archive)	před 7 years
	What is the intended result of that sequence - to do the mes... In forum Others (Archive)	před 7 years
	What filament are the printed parts made from? (Yeah - Again... In forum Others (Archive)	před 7 years
	Can I assume the silence means nobody ever gets good first l... In forum Others (Archive)	před 7 years
	How do you get good first layer height consistency? In forum Others (Archive)	před 7 years
	Super unfortunate. Running into the same issue today. What's... In forum Print tips (Archive)	před 7 years
	I definitely agree that I like to be able to clearly see the... In forum Others (Archive)	před 7 years
	Genius! So simple, yet so not-obvious, and makes SO much dif... In forum Others (Archive)	před 7 years

Stránka 3 / 3 Předchozí

Fórum Statistiky

559 Fóra

63.1 K Témata

443.9 K Příspěvky

21 Online

68.1 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed