|
Did you read the previous post?
I have had NO further issues... In forum Assembly and first prints troubleshooting |
6 years temu |
|
As mentioned on another thread: , I kept getting 'BED PREHEA... In forum Hardware, firmware and software help |
6 years temu |
|
Bed preheat error with v3.5.x In forum Assembly and first prints troubleshooting |
6 years temu |
|
- I added springs to the Bowden attachment on the filament s... In forum Assembly and first prints troubleshooting |
6 years temu |
|
Hmm, downgraded to v3.5.0 - now have X and Y shift at around... In forum Hardware, firmware and software help |
6 years temu |
|
X Layer shifts on long prints since upgrading to v3.5.1 In forum Hardware, firmware and software help |
6 years temu |
|
Another unhappy MMU2 customer here. (...)
Hi Alan,
Thank ... In forum Assembly and first prints troubleshooting |
6 years temu |
|
Another unhappy MMU2 customer here.
I've been fighting the M... In forum Assembly and first prints troubleshooting |
6 years temu |
|
I was still getting a little stringing with PLA on my MMU wi... In forum General discussion, announcements and releases |
7 years temu |
|
is this for mk2 or 3?
Mk2, non MMU. MK3 is here: .
I create... In forum General discussion, announcements and releases |
7 years temu |
|
I improved your profile a bit (attached).
I sorted the print... In forum General discussion, announcements and releases |
7 years temu |
|
Thanks, that imported fine.
However, I found the cause of th... In forum General discussion, announcements and releases |
7 years temu |
|
Update, recevied response from S3D Support:
Thanks for the... In forum General discussion, announcements and releases |
7 years temu |
|
Definitely seems to be something wrong with the file, as I c... In forum General discussion, announcements and releases |
7 years temu |
|
I'm on v4.0.1
Have contacted S3D support (on friday), no res... In forum General discussion, announcements and releases |
7 years temu |
|
I'm trying to import your profile. Some aspects are importin... In forum General discussion, announcements and releases |
7 years temu |
