Notifications
Clear all
alan.d3
alan.d3
Group: Registered
Joined: 2017/06/27
Active Member
1
Did you read the previous post? I have had NO further issues...

In forum Assembly and first prints troubleshooting

6 years ago
As mentioned on another thread: , I kept getting 'BED PREHEA...

In forum Hardware, firmware and software help

6 years ago
Bed preheat error with v3.5.x

In forum Assembly and first prints troubleshooting

6 years ago
- I added springs to the Bowden attachment on the filament s...

In forum Assembly and first prints troubleshooting

6 years ago
Hmm, downgraded to v3.5.0 - now have X and Y shift at around...

In forum Hardware, firmware and software help

6 years ago
X Layer shifts on long prints since upgrading to v3.5.1

In forum Hardware, firmware and software help

6 years ago
Another unhappy MMU2 customer here. (...) Hi Alan, Thank ...

In forum Assembly and first prints troubleshooting

6 years ago
Another unhappy MMU2 customer here. I've been fighting the M...

In forum Assembly and first prints troubleshooting

6 years ago
I was still getting a little stringing with PLA on my MMU wi...

In forum General discussion, announcements and releases

7 years ago
is this for mk2 or 3? Mk2, non MMU. MK3 is here: . I create...

In forum General discussion, announcements and releases

7 years ago
I improved your profile a bit (attached). I sorted the print...

In forum General discussion, announcements and releases

7 years ago
Thanks, that imported fine. However, I found the cause of th...

In forum General discussion, announcements and releases

7 years ago
Update, recevied response from S3D Support: Thanks for the...

In forum General discussion, announcements and releases

7 years ago
Definitely seems to be something wrong with the file, as I c...

In forum General discussion, announcements and releases

7 years ago
I'm on v4.0.1 Have contacted S3D support (on friday), no res...

In forum General discussion, announcements and releases

7 years ago
I'm trying to import your profile. Some aspects are importin...

In forum General discussion, announcements and releases

7 years ago
Share: