|
The XYZ Calibration does not sense the PINDA position, but m... Dans le forum Prusa i3 kit (Archive) |
il y a 8 years |
|
One question:
I see raised letters come out fine on a flat... Dans le forum Software (Archive) |
il y a 8 years |
|
Okay.
First. Have you loaded the .ini file (Mac) (I think ... Dans le forum Others (Archive) |
il y a 8 years |
|
Yes, Slic3r no longer does the prime line in the "start gcod... Dans le forum Others (Archive) |
il y a 8 years |
|
Try a "factory reset". Sometime the machine keeps things i... Dans le forum Others (Archive) |
il y a 8 years |
|
Yup. Not that. Sorry.
Can't think of anything else but wi... Dans le forum Others (Archive) |
il y a 8 years |
|
I have never seen this behavior, so I am guessing:
1) Make ... Dans le forum Others (Archive) |
il y a 8 years |
|
Just guessing, but I am guessing you installed the firmware ... Dans le forum Others (Archive) |
il y a 8 years |
|
Make sure the bed is perfectly clean (clean with pure aceton... Dans le forum Others (Archive) |
il y a 8 years |
|
First, you really should not upgrade to MMU until you have t... Dans le forum Others (Archive) |
il y a 8 years |
|
tried Cura, stock Slic3r, and Slic3r Prusa Edition, Simplify... Dans le forum Prusa i3 kit (Archive) |
il y a 8 years |
|
These were all printed with 0.15mm layer height.
At this... Dans le forum Prusa i3 kit (Archive) |
il y a 8 years |
|
I printed PETG without preparing the surface, popped of the ... Dans le forum Others (Archive) |
il y a 8 years |
|
First, the printer doesn't print well upside down. (Just jo... Dans le forum Print tips (Archive) |
il y a 8 years |
|
Re: First Layer Advice Dans le forum Others (Archive) |
il y a 8 years |
|
Use the regular old non-MMU version and choose the "Original... Dans le forum Others (Archive) |
il y a 8 years |
|
Try the 0.2mm settings. This fast 0.35 one can be a bit wo... Dans le forum Print tips (Archive) |
il y a 8 years |
|
Please see these two threads: Dans le forum Print tips (Archive) |
il y a 8 years |
|
The post processor was only used in the very early versions ... Dans le forum Others (Archive) |
il y a 8 years |
|
Just guessing (hard to tell from the photos), but I would ch... Dans le forum Others (Archive) |
il y a 8 years |
