AJS – Attività – Prusa3D Forum

Notifiche

Cancella tutti

AJS

Gruppo: Registrato

Registrato: 2017/01/10

Noble Member

	You are thinking correct, and your design looks great at low... Nel forum Others (Archive)	8 years fa
	I might also suggest upgrading to a Raspberry Pi with OctoPi... Nel forum Others (Archive)	8 years fa
	Poor layer adhesion can also be a result of a bad temperatur... Nel forum Others (Archive)	8 years fa
	Is your PINDA probe security mounted? If it moves, then tha... Nel forum Others (Archive)	8 years fa
	That first layer looks good to me. Certainly not a first la... Nel forum Others (Archive)	8 years fa
	I would check the connections to the bed and the cable from ... Nel forum Others (Archive)	8 years fa
	Also check belts and motor as mentioned above. Even though... Nel forum Others (Archive)	8 years fa
	Is the cable bundle that comes out the back of the extruder ... Nel forum Others (Archive)	8 years fa
	I have no time to go back and forth and do an A/B comparison... Nel forum Improvements (Archive)	8 years fa
	Does it have this bad behavior on one of the included files?... Nel forum Others (Archive)	8 years fa
	Is this a packaged gcode, or one you sliced yourself? Are y... Nel forum Others (Archive)	8 years fa
	Does this happen on multiple filament rolls, or just this on... Nel forum Others (Archive)	8 years fa
	Thanks all! Nel forum Others (Archive)	8 years fa
	Sam, A picture is worth a thousand words... I did have som... Nel forum Others (Archive)	8 years fa
	Looks like under extrusion to me. Three things to try: 1) C... Nel forum Others (Archive)	8 years fa
	Variable Fill Density Nel forum Others (Archive)	8 years fa
	Your description reminds me of this post: The problem the... Nel forum Others (Archive)	8 years fa
	Also extruder parts with probe holder currently being design... Nel forum Improvements (Archive)	8 years fa
	OK, so that GCode starts with extruder 1, prints the purge l... Nel forum Others (Archive)	8 years fa
	The nozzle does NOT affect leveling. That is all done with ... Nel forum Improvements (Archive)	8 years fa

Pagina 49 / 51 Precedente Avanti

Statistiche Forum

585 Forum

68.3 K Discussioni

478.4 K Post

11 Online

76.2 K Utenti

Post recenti: Prusaslicer adding deretract commands for vase mode prints Ultimo utente registrato: rhn Post recenti Post da leggere Etichette

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso