AJS – Activité – Prusa3D Forum

Notifications

Clear all

AJS

Groupe: Enregistré

A(ont) rejoint: 2017/01/10

Noble Member

	You are thinking correct, and your design looks great at low... Dans le forum Others (Archive)	il y a 8 years
	I might also suggest upgrading to a Raspberry Pi with OctoPi... Dans le forum Others (Archive)	il y a 8 years
	Poor layer adhesion can also be a result of a bad temperatur... Dans le forum Others (Archive)	il y a 8 years
	Is your PINDA probe security mounted? If it moves, then tha... Dans le forum Others (Archive)	il y a 8 years
	That first layer looks good to me. Certainly not a first la... Dans le forum Others (Archive)	il y a 8 years
	I would check the connections to the bed and the cable from ... Dans le forum Others (Archive)	il y a 8 years
	Also check belts and motor as mentioned above. Even though... Dans le forum Others (Archive)	il y a 8 years
	Is the cable bundle that comes out the back of the extruder ... Dans le forum Others (Archive)	il y a 8 years
	I have no time to go back and forth and do an A/B comparison... Dans le forum Improvements (Archive)	il y a 8 years
	Does it have this bad behavior on one of the included files?... Dans le forum Others (Archive)	il y a 8 years
	Is this a packaged gcode, or one you sliced yourself? Are y... Dans le forum Others (Archive)	il y a 8 years
	Does this happen on multiple filament rolls, or just this on... Dans le forum Others (Archive)	il y a 8 years
	Thanks all! Dans le forum Others (Archive)	il y a 8 years
	Sam, A picture is worth a thousand words... I did have som... Dans le forum Others (Archive)	il y a 8 years
	Looks like under extrusion to me. Three things to try: 1) C... Dans le forum Others (Archive)	il y a 8 years
	Variable Fill Density Dans le forum Others (Archive)	il y a 8 years
	Your description reminds me of this post: The problem the... Dans le forum Others (Archive)	il y a 8 years
	Also extruder parts with probe holder currently being design... Dans le forum Improvements (Archive)	il y a 8 years
	OK, so that GCode starts with extruder 1, prints the purge l... Dans le forum Others (Archive)	il y a 8 years
	The nozzle does NOT affect leveling. That is all done with ... Dans le forum Improvements (Archive)	il y a 8 years

Page 49 / 51 Précédent Suivant

Statistiques du forum

585 Forums

68.3 K Sujets

478.4 K Messages

12 En-ligne

76.2 K Membres

Le dernier des messages: Prusa Core one clicking while purging / printing and uneven purging Notre nouveau membre: rhn Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé