Notifications
Clear all
adechiaro
Groupe: Enregistré
A(ont) rejoint: 2024/09/22
Active Member
1
|
Well, I have another update and believe I figured out the is... Dans le forum How do I print this? (Printing help) |
il y a 4 months | |
|
I opened a fresh roll of Prusament PLA, tossed in the dryer ... Dans le forum How do I print this? (Printing help) |
il y a 4 months | |
|
Would there be any specific settings which may contribute to... Dans le forum How do I print this? (Printing help) |
il y a 4 months | |
|
I prepared another similar model to the figurine, sliced, sa... Dans le forum How do I print this? (Printing help) |
il y a 4 months | |
|
Apologies for the confusion. Yes, I did use supports but I ... Dans le forum How do I print this? (Printing help) |
il y a 4 months | |
|
Thank you! Here is the project from PrusaSlicer 2.8.0 zippe... Dans le forum How do I print this? (Printing help) |
il y a 4 months | |
|
Small blobs on underside of prints Dans le forum How do I print this? (Printing help) |
il y a 4 months |