|
Okay. Was able today to just fool around with the printer, a... In forum Print tips (Archive) |
9 years temu |
|
Yes, it was 0.2mm for the first layer on my print compared t... In forum Print tips (Archive) |
9 years temu |
|
Okay, I got NP++ and opened them both up to compare. The fai... In forum Print tips (Archive) |
9 years temu |
|
I dug through them all earlier, and they appeared to be an e... In forum Print tips (Archive) |
9 years temu |
|
I started Adalinda, and stopped it at 10% as I don't have en... In forum Print tips (Archive) |
9 years temu |
|
Is there a good small one to try on there with infill?
I c... In forum Print tips (Archive) |
9 years temu |
|
Layer separation and bad infill, but perfect when hollow? In forum Print tips (Archive) |
9 years temu |
|
I haven't tried varying the temperature yet, but I am please... In forum Print tips (Archive) |
9 years temu |
|
Bruce.w and adam.f2, I have found a great design for replaci... In forum Prusa i3 kit (Archive) |
9 years temu |
|
Will give it a shot in a bit, and see how it goes. Thanks fo... In forum Print tips (Archive) |
9 years temu |
|
I saw your print with the Woodfill. Very nice, actually have... In forum Print tips (Archive) |
9 years temu |
|
I'm going to chime in on this one as well. Same overall exp... In forum Prusa i3 kit (Archive) |
9 years temu |
|
Any tips for printing with Wood, Bronze or Laybrick? In forum Print tips (Archive) |
9 years temu |
|
Oddly enough, the frame was twisted last week when I was act... In forum Prusa i3 kit (Archive) |
9 years temu |
|
High in the middle on calibration In forum Prusa i3 kit (Archive) |
9 years temu |
|
Sorry for the delayed response, was tied up with work and un... In forum Prusa i3 kit (Archive) |
9 years temu |
|
Thanks for the photo, that helped quite a bit.
I rechecked ... In forum Prusa i3 kit (Archive) |
9 years temu |
|
I haven't done anything yet, but everything is exactly as it... In forum Prusa i3 kit (Archive) |
9 years temu |
|
That looks amazing. Those types of masks have always been co... In forum Awesome prints (Hall Of Fame) |
9 years temu |
|
Extruder body not lined up with pulley and tube In forum Prusa i3 kit (Archive) |
9 years temu |
