Avisos
Vaciar todo
Abiathar
Grupo: Registrado
Registrado: 2019/04/07
Active Member
1
| I run one and like the improvement it gave. No heat creep in... | hace 5 years | |
| Try this one. I believe it is the one I used. | hace 6 years | |
|
Have rebuilt the X and Y axis to make sure they are good and... En el foro Assembly and first prints troubleshooting |
hace 6 years | |
|
The tower printed out near perfect, no apparent artifacts. W... En el foro Assembly and first prints troubleshooting |
hace 6 years | |
|
Thanks, I'll check on that later. After reseating and checki... En el foro Assembly and first prints troubleshooting |
hace 6 years | |
|
Printing the tower now to test, but there is not a E-Correct... En el foro Assembly and first prints troubleshooting |
hace 6 years | |
|
Artifacts on side of included benchy En el foro Assembly and first prints troubleshooting |
hace 6 years |