Prusa3D Forum

Notifications

Clear all

Abiathar

Skupina: Registrovaný

Přidal se: 2019/04/07

Active Member

	I run one and like the improvement it gave. No heat creep in... In forum User mods - OctoPrint, enclosures, nozzles, ...	před 5 years
	Try this one. I believe it is the one I used. In forum User mods - OctoPrint, enclosures, nozzles, ...	před 6 years
	Have rebuilt the X and Y axis to make sure they are good and... In forum Assembly and first prints troubleshooting	před 6 years
	The tower printed out near perfect, no apparent artifacts. W... In forum Assembly and first prints troubleshooting	před 6 years
	Thanks, I'll check on that later. After reseating and checki... In forum Assembly and first prints troubleshooting	před 6 years
	Printing the tower now to test, but there is not a E-Correct... In forum Assembly and first prints troubleshooting	před 6 years
	Artifacts on side of included benchy In forum Assembly and first prints troubleshooting	před 6 years

Fórum Statistiky

566 Fóra

63.1 K Témata

444.1 K Příspěvky

25 Online

68.1 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed