3DCoded – Activité – Prusa3D Forum

Notifications

Clear all

3DCoded

Groupe: Enregistré

A(ont) rejoint: 2022/08/30

Eminent Member

	I was able to get Prusament PLA to stick pretty well by doin... Dans le forum Hardware, firmware and software help	il y a 3 years
	Thank you for all your help! I used the glue stick and disso... Dans le forum How do I print this? (Printing help)	il y a 3 years
	That's exactly what I ended up doing! Dans le forum How do I print this? (Printing help)	il y a 3 years
	I just received my TPU and started printing with it before I... Dans le forum How do I print this? (Printing help)	il y a 3 years
	I will be sure to try that. Thank you! Dans le forum How do I print this? (Printing help)	il y a 3 years
	Thank you for the advice! I will try the included glue stick... Dans le forum How do I print this? (Printing help)	il y a 3 years
	Can I use the gluestick that comes with my MK3S+? The gluest... Dans le forum How do I print this? (Printing help)	il y a 3 years
	Printing TPU on Smooth Sheet on MK3S+? Dans le forum How do I print this? (Printing help)	il y a 3 years
	Are you using the recommended OctoPrint MK3S+ profile atWhat... Dans le forum User mods - OctoPrint, enclosures, nozzles, ...	il y a 3 years

Page 3 / 3 Précédent

Statistiques du forum

585 Forums

68.2 K Sujets

477.9 K Messages

12 En-ligne

75.9 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé