Notifications
Clear all
3DCoded
Skupina: Registrovaný
Přidal se: 2022/08/30
Eminent Member
2
|
I was able to get Prusament PLA to stick pretty well by doin... In forum Hardware, firmware and software help |
před 2 years | |
|
Thank you for all your help! I used the glue stick and disso... In forum How do I print this? (Printing help) |
před 2 years | |
|
That's exactly what I ended up doing! In forum How do I print this? (Printing help) |
před 2 years | |
|
I just received my TPU and started printing with it before I... In forum How do I print this? (Printing help) |
před 2 years | |
|
I will be sure to try that. Thank you! In forum How do I print this? (Printing help) |
před 2 years | |
|
Thank you for the advice! I will try the included glue stick... In forum How do I print this? (Printing help) |
před 2 years | |
|
Can I use the gluestick that comes with my MK3S+? The gluest... In forum How do I print this? (Printing help) |
před 2 years | |
|
Printing TPU on Smooth Sheet on MK3S+? In forum How do I print this? (Printing help) |
před 2 years | |
| Are you using the recommended OctoPrint MK3S+ profile atWhat... | před 2 years |
Stránka 3 / 3
Předchozí