Unscheduled pause after heating on Octoprint
I run a couple of MINI's through Octoprint and I noticed a new issue about a month ago: When I start a print file it always pauses after the hotend heats up. There is no scheduled pause in the gcode from prusaslicer and I can't find any setting in the octoprint that would seem to cause this behavior. Does anyone have any ideas??
Here's the G-code from when it happens.
Recv: echo:busy: processing
Recv: T:166.47 /170.00 B:47.57 /60.00 A:35.59 /0.00 @:51 B@:127 W:?
Recv: T:166.49 /170.00 B:47.62 /60.00 A:35.63 /0.00 @:52 B@:127
Recv: T:167.02 /170.00 B:47.98 /60.00 A:35.59 /0.00 @:50 B@:127 W:?
Recv: echo:busy: processing
Recv: T:167.48 /170.00 B:48.22 /60.00 A:35.83 /0.00 @:49 B@:127 W:?
Recv: T:167.65 /170.00 B:48.42 /60.00 A:35.77 /0.00 @:49 B@:127
Recv: T:167.94 /170.00 B:48.63 /60.00 A:35.88 /0.00 @:48 B@:127 W:0
Recv: ok
Send: N13 M400*21
Recv: ok
Send: N14 M114*18
Recv: X:178.00 Y:178.00 Z:40.00 E:14.50 Count X:17840 Y:17800 Z:16211
Recv: ok
Changing monitoring state from "Pausing" to "Paused"