E3D V6 Hotend
Hi all,
So, I have seen a few folks have added E3D V6 hot ends to their Mini’s. I saw this guys setup and thought it looked interesting. Anyone on forums done it?
https://www.prusaprinters.org/prints/42172-hotend-mount-for-e3d-v6-and-compatible-hotends-for
I picked up the hot end on eBay. Not expensive. Like $10.
i bought the clone to tinker with, so this looks like a fun mod.
minis
Hi all,
So, I have seen a few folks have added E3D V6 hot ends to their Mini’s. I saw this guys setup and thought it looked interesting. Anyone on forums done it?
https://www.prusaprinters.org/prints/42172-hotend-mount-for-e3d-v6-and-compatible-hotends-for
I picked up the hot end on eBay. Not expensive. Like $10.
i bought the clone to tinker with, so this looks like a fun mod.
Yes. I have one V6 and one Dragon on two of my minis.
--------------------
Chuck H
3D Printer Review Blog
Firmware
Did you have to change anything after install? Firmware, PID tuning, etc?
V6
Did you have to change anything after install? Firmware, PID tuning, etc?
I adjusted the flow rate and with some filaments, the temps are slightly different.
--------------------
Chuck H
3D Printer Review Blog
Thanks!
Thank you.