Notifications
Clear all

I made a raspberry pi 4 mount  

  RSS
tjmaxal
(@tjmaxal)
Active Member
I made a raspberry pi 4 mount

I posted this up on printables.

https://www.printables.com/model/272435-raspberry-pi-4-mount-for-prusa-enclosure

I made an enclosure mount for the raspberry pi 4 i have mine opposite of the tool holder but you could remix it to mount anywhere really. 

Best Answer by tjmaxal:

I posted this up on printables.

https://www.printables.com/model/272435-raspberry-pi-4-mount-for-prusa-enclosure

I made an enclosure mount for the raspberry pi 4 i have mine opposite of the tool holder but you could remix it to mount anywhere really. 

Posted : 07/09/2022 1:19 am
cwbullet
(@cwbullet)
Member
RE: I made a raspberry pi 4 mount

I like it!  Thanks for sharing.  The enclosure will be my next purchase.  

--------------------
Chuck H
3D Printer Review Blog

Posted : 11/09/2022 1:25 pm
PhilW
(@philw-2)
Active Member
RE: I made a raspberry pi 4 mount

@tjmaxal Just about to print off a variation for the RPI 3+ - which way up did you print the base with the mount attached? Thanks!

Posted : 01/10/2022 9:44 am
Jdub
 Jdub
(@jdub-2)
New Member
RE:

@philw-2 Did you happen to make this yet?

Posted : 12/12/2022 1:03 am
PhilW
(@philw-2)
Active Member
RE: I made a raspberry pi 4 mount

I did - not sure how successful it is yet as I haven't bult the enclosure so haven't tried to attach the mount to it - as my enclosure extras have only fairly receently arrived...

Posted : 12/12/2022 11:41 am
tjmaxal liked
Share: