Notifications
Clear all
Flat LCD support
Really liking the enclosure, but for my place of work to use it it'd be great if it was less deep. Our printers recide in a not too wide corridor that receives a lot of foot traffic & someone will bump into the LCD if it's mounted as is.
So I made a flat LCD support. 🙂 One thing to note is that the LCD is now the lowest point of the whole enclosure, so it can't sit on the ground. 🙂
Now on to the next project: side-mounted PSU 😀
Posted : 15/09/2022 12:44 pm
PeterT liked
Topic starter
answered:
RE: Flat LCD support
forgot to include a link: https://www.printables.com/model/276718-prusa-enclosure-flat-lcd-support
Posted : 15/09/2022 1:21 pm