Avisos
Vaciar todo
Variable Infill?
Hi all -
I hope I'm in the right place for this question: I'd like to create a variable amount of infill. I have a very "fine" part of a print, about 1mm thick, and I would like that to be as dense as possible. I also have a very broad part of a print, a 48x48mm base stand, and I'd like that to be fairly light on the infill. Is there a way to set these parameters in PrusaSlicer?
Respondido : 09/12/2025 1:30 am
RE: Variable Infill?
Check out https://help.prusa3d.com/article/modifiers_1767
or for regions not defined by height use regular modifiers but they're a pain to apply precisely
Formerly known on this forum as @fuchsr -- https://foxrun3d.com/
Respondido : 09/12/2025 3:48 pm