using prusaslicer with a ratrig
 
Notifications
Clear all

using prusaslicer with a ratrig  

  RSS
toaf
 toaf
(@toaf)
Noble Member
using prusaslicer with a ratrig

hello, i have super slicer working good, but for some reason the bottom and top infills aren't connecting to the perimeters. and there is a big gap in the perimeter where the seem is.  ive looked over all the setting to compare them but i just cant find a magic setting. any idea would be great.  thanks.

I have a Prusa,therefore I research.

Napsal : 14/07/2023 5:54 am
OrKaraz
(@orkaraz)
Active Member
RE: using prusaslicer with a ratrig

Hi, i'm using a ratrig too (V3.1 with Marlin, custom config). I have not this problem. (maybe the "chevauchement", sorry i'm in french version, Print option > Advanced > just under extrud width)

If you need more help, you can contact me on discord : OrKaraz (picture : a red electronic circuit)

Napsal : 17/07/2023 4:05 pm
Share: