Notifications
Clear all
The line width on interserting perimeters is vase mode is not adjusted
Dear all,
When Prusa generates outer wall in vase mode, it does not adjust line width (or extrusion rate) on intersecting perimeters. When the extruder goes the second time over the same position, the extruded filament cannot lay down nicely and starts to overflow to the side. This gets especially visible on the narrow part of the vase, when the perimeter gets "condensed".
Posted : 26/12/2024 2:46 pm
That model is not suitable for vase mode.
Cheerio,
Posted : 26/12/2024 4:36 pm