Notifications
Clear all
Supports with dual extrusion
Hello,
I'm trying to setup a dual extrusion print which needs supports.
The problem is that supports are generated for each printhead ignoring the presence of the other material.
What's wrong in my config ?
Posted : 18/12/2022 7:47 pm
RE: Supports with dual extrusion
That's very difficult to tell without your project file.
You are probably doing something wrong. The problem will most certainly go away when you do it right.
If at first you don't succeed, skydiving is not for you.
Find out why this is pinned in the general section!
Posted : 20/12/2022 4:32 pm
Topic starter
answered:
RE: Supports with dual extrusion
Thanks Robin,
That's right I wasn't very clear.
I understood that the different parts have to be merged before slicing
Posted : 25/12/2022 7:50 pm