Notifications
Clear all
Support Enforcer Issues
Morning
I'm having issues with the support enforcers which I cannot get my head around, I added a support enforcer to a model I wanted to print, but its only adding a very small support which don't stop the overhang on the top going wrong.
This is how I had the enforcer setup within slicer and some of my rough settings, but below is how it slices when generated when the layers are dropped to see.
Any ideas as its doing my head in trying to get it right.
Opublikowany : 03/01/2020 10:52 am
Topic starter
answered:
RE: Support Enforcer Issues
Found the reason, needed to deselect the "don't support bridges" option in print settings.
Opublikowany : 08/01/2020 5:53 pm
Ty polubić