Notifications
Clear all
Still missing 3DLabPrint type internal surfaces using Even/Odd slicing mode
So slicing my plane with the Prusaslicer did not work. There are still internal walls missing even using the Even/Odd setting. Very disappointing. This does not happen with Simplify3D or Cura.
On consultation with Prusa they actually advised me to use Cura!
The plane can be found here:
Attached is the project file
This topic was modified 3 years ago 3 times by Jackheli
Posted : 28/02/2022 1:55 am
Topic starter
answered:
RE: Still missing 3DLabPrint type internal surfaces using Even/Odd slicing mode
Prusa followed up on the issue and gave me the solution! Amazing!
Change the "Slice gap closing radius" under Print settings - Advance to 0.001 mm
Back in business.
Posted : 28/02/2022 3:41 am