Notifications
Clear all
Spiral vase mode with a multiple extrusion widths?
I am 3D printing propeller blades for rubber band airplanes using spiral vase mode, and I want them to be very thin, except in some spots. I was hoping that I could use a modifier for extrusion width, but PrusaSlicer treats a modifier as another part and says I can't do it in spiral vase mode. Is there a way to do spiral vase with some thicker extrusions in some spots?
Publié : 19/04/2022 7:53 pm
RE: Spiral vase mode with a multiple extrusion widths?
Hi,
your troubles seems quite well connected with:
https://github.com/prusa3d/PrusaSlicer/issues/7973
https://github.com/prusa3d/PrusaSlicer/issues/7447
It seems that PrusaSlicer should achieve a big improvement in the gap fill/perimeters handling.
Good luck and have a good printing!
Publié : 02/05/2022 9:49 am