Notifications
Clear all
Remove bottom layer so that infil pattern shows through.
Hey guys, I tried searching through the forum and I guess I wasn't typing the correct key words, because I couldn't find anything on this. Does anyone know how to remove the bottom layers so that the infil pattern can show through on the bottom? I've done it with cura, but having recently purchased a mk3s+, I would like to do it with prusa slicer.
Any help is appreciated, thanks.
Best Answer by sylviatrilling:
Print Settings > Layers and Perimeters > Horizontal Shells > Bottom set to 0
Posted : 17/02/2022 9:33 pm
RE: Remove bottom layer so that infil pattern shows through.
Print Settings > Layers and Perimeters > Horizontal Shells > Bottom set to 0
Mk3S+,SL1S
Posted : 17/02/2022 10:15 pm
SnapArmor liked
Topic starter
answered:
RE: Remove bottom layer so that infil pattern shows through.
Thank you! Much appreciated
Posted : 17/02/2022 10:28 pm