Notifications
Clear all
PrusaSlicer Pressure Equalizer with Klipper Pressure Advance
I have been using PrusaSlicer Pressure Equalizer with a machine running Klipper firmware with Pressure Advance enabled. Does anyone here know if these two conflict with each other? They seem to work fine so far, but I do get small artifacts and was wondering if there were any known issues between the two features?
Opublikowany : 12/09/2022 4:37 pm
RE: PrusaSlicer Pressure Equalizer with Klipper Pressure Advance
@AMV
You must tune Pressure Equalizer to get rid of artifacts (two experimental options). PA and PE have different tasks and can work together.
Opublikowany : 14/09/2022 9:28 am
AMV polubić