PrusaSlicer import of Printer Profile fails

Dernier message

RSS

toshi

(@toshi)

Active Member

PrusaSlicer import of Printer Profile fails

Dear All,

I am currently failing to import a zipped printer profile from a Caribou/Zaribou printer (based on Mk3).

PrusaSlicer reports "Failed to extract local archive".

I am using Debian/Linux, and PrusaSclicer 2.8.1.

Any Ideas what I am doing wrong?

Thanks
Stephan

55897431-pasted-from-clipboard.png

Publié : 25/11/2024 7:50 pm

Neophyl

(@neophyl)

Illustrious Member

RE: PrusaSlicer import of Printer Profile fails

Could be many reasons, without the archive you are trying it’s impossible to say. Also an exact description of the steps you are following to import it would also be needed.

Publié : 25/11/2024 8:17 pm

Statistiques du forum

559 Forums

63.1 K Sujets

443.8 K Messages

20 En-ligne

68 K Membres

Le dernier des messages: When running PrusaSlicer 2.8.1 via flatpak, the application can't see /mnt Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé