Notifications
Clear all
Prusaslicer imbeds Print Settings >Notes in gcode
I hope I am not re-inventing the wheel here, but I could not find anything in the forum about a good reason to put comments in Print Settings > Notes in PrusaSlicer. The old-timers will know this, but newer people may not as PrusaSlicer is so feature rich it is a constant case of learning what it can do.
The comments entered there will be added to the gcode file header so any information on the print will travel with both the 3MF file and the gcode file.
results in this entry into gcode file header:
\I can see putting information like <website>ID, <filename>.3MF, version, licence, depository, phase of the moon, etc..
Kenn
Quality is the Journey, not the Destination. My limited prints->
Opublikowany : 17/11/2021 2:27 am