PrusaSlicer 2.6 First Layer doubling up not moving over a row on each pass
So I started to see this develop after my change to 2.6. When the nozzle is paying down the first layer. Let's say along the x axis. It will travel north letdown filament and then should move over a row and head south laying down filament. What its doing now is heading north laying down filament, then going back over the same path with more filament and then when it gets back ot the end of the south direction it moves over a row and begins again. Whats its doing is giving the first layer the appearance of too close and I kept adjusting my Z offset in tuning to get it to look better and then finding its too far away and created obviously a whole diffenrt set of issues. It took me a while to figure it out. I ran the same model with Cura and prints perfectly first layer but Slicer 2.6.
Any thoughts.
Printer is ender 3 V2 with sprite hot end 4.2.7 board using PLA.
Thanks
Keith