Prusaslicer 2.4.1 empty plater forced to save

Ostatni Post

RSS

angelus0313

(@angelus0313)

Active Member

Prusaslicer 2.4.1 empty plater forced to save

I've been getting an odd problem as of late. When I try to close out Prusaslicer (2.4.1) with an empty plater it always make me have to save the empty plater as a project. Noticed at first I thought I was because I load an stl, then delete it from the plater. But, did some more testing and found that even when I open it then try to close the program it still comes up with this message.

I've looked through the settings to see if I had something checked, but I did not find anything directly causing this. Unless it is named something odd. I've included a picture of what it is doing to this post