Prusaslicer 2.3 rc2 and Sidewinder X1, problem ....  

RE: Prusaslicer 2.3 rc2 and Sidewinder X1, problem ....

@bobstro

I still have exactly the same problem, the nozzle heats up to 160 °, then moves to the left corner and in front, goes down against the plate and heats up to 200 ° before launching the print.

Isn't there a buffer problem somewhere?

RE: Prusaslicer 2.3 rc2 and Sidewinder X1, problem ....

I can not edit my message (really too bad ..), I just tried on the RC3, and the behavior is almost identical except that the nozzle goes up a little after the home in the corner, it does not is therefore not against the bed.

RE: Prusaslicer 2.3 rc2 and Sidewinder X1, problem ....

Ah, forgot you don't have ABL. Comment out line 66.

Don't worry about the 160C. It waits for the nozzle to be at least 160C before moving. So long as it immediately starts heating as it homes, it is working correctly. 

RE: Prusaslicer 2.3 rc2 and Sidewinder X1, problem ....

@bobstro

Thank you very much for your help 🙂